skip to main content
Ngôn ngữ:
Giới hạn tìm kiếm: Giới hạn tìm kiếm: Dạng tài nguyên Hiển thị kết quả với: Hiển thị kết quả với: Chỉ mục

Microstructural homogeneity and superplastic behavior in an aluminum-copper eutectic alloy processed by high-pressure torsion

Kawasaki, Megumi ; Lee, Han-Joo ; Langdon, Terence G.

Journal of Materials Science, July 24, 2015, Vol.50, p.6700(13) [Tạp chí có phản biện]

ISSN: 0022-2461 ; DOI: 10.1007/s10853-015-9224-5

Toàn văn sẵn có

Trích dẫn Trích dẫn bởi
  • Nhan đề:
    Microstructural homogeneity and superplastic behavior in an aluminum-copper eutectic alloy processed by high-pressure torsion
  • Tác giả: Kawasaki, Megumi ; Lee, Han-Joo ; Langdon, Terence G.
  • Chủ đề: Hardness (Materials) – Mechanical Properties ; Aluminum Casting Alloys – Mechanical Properties ; Specialty Metals Industry – Mechanical Properties
  • Là 1 phần của: Journal of Materials Science, July 24, 2015, Vol.50, p.6700(13)
  • Mô tả: An Al-33 % Cu eutectic alloy was processed by high-pressure torsion (HPT) at room temperature under a compressive pressure of 6.0 GPa for different revolutions up to 10 turns. The Vickers microhardness and microstructure were investigated on vertical cross sections of the disks to evaluate the evolution toward homogeneity with increasing numbers of HPT turns. The hardness behavior follows the strain hardening model of materials after HPT processing and the microstructural development confirms that there is essentially a compatibility between hardness and microstructure in the Al-Cu alloy when processing by HPT. The tensile properties were examined at a high temperature of 723 Kafter5 and 10 turns of HPT using a series of strain rates from 3.3 x [10.sup.-5] to 1.0 x [10.sup.-1] [s.sup.-1]. Excellent superplastic ductilities were achieved when testing at strain rates below 1.0 x [10.sup.-3] [s.sup.-1] with a highest elongation of ~1220 % after 10 turns at an initial strain rate of 1.0 x [10.sup.-4] [s.sup.-1]. Close inspection showed that the optimal superplastic strain rates are displaced to a faster strain rate with increasing revolutions from 5 to 10 turns. A deformation mechanism map was constructed for a testing temperature of 723 K using a combination of theoretical relationships and earlier experimental data reported for a conventional coarse-grained Al-33 % Cu alloy. Inspection shows that this map is in excellent agreement with the experimental data for the ultrafine-grained Al-33 % Cu alloy after processing by HPT.
  • Ngôn ngữ: English
  • Số nhận dạng: ISSN: 0022-2461 ; DOI: 10.1007/s10853-015-9224-5

Đang tìm Cơ sở dữ liệu bên ngoài...